Manual use of the connected motor control, Zigbee®, Swiss line

Configuration

The connected motor control, Zigbee^®, Swiss line operates out of the box in stand-alone use and does not require configuration. The run times to open/close the shutter or blind are set to one and a half minutes. Briefly press one of the push buttons to activate its corresponding built-in relay contact. This will cause the connected 230 V motor to rotate in a certain direction. The motor will stop spinning when the run time has elapsed or when one of two push buttons is pressed briefly. The active feedback LEDs indicate which button is to be pressed next.

A connected motor control, Zigbee^®, Swiss line that is used in stand-alone mode will not use the mesh networking capability and will not be upgraded automatically. For more details, refer to Zigbee® network principle.

Feedback LED

 If you use a central plate without lens (xxx-31006), you can disable the feedback LED by pressing the PROG button for 10 seconds.

	Disable the white feedback LED	The white feedback LED is active by default. Press the PROG button for 10 seconds. The blue LED turns ON after 2 seconds and subsequently turns OFF after 10 seconds. The white LED is disabled
	Enable the white feedback LED (after it has been disabled)	Press the PROG button for 10 seconds. The blue LED turns ON after 2 seconds and subsequently turns OFF. The white LED lights up again when the connected switch, Zigbee® is used