Skip to main content
Skip table of contents

Maintenance and troubleshooting the DALI-2 addressable module

Upgrading the DALI-2 addressable module

When an upgrade is needed, the status LED on the module flashes.

During the uploading process of your project to your Niko Home Control installation, you have the option to upgrade the module.

Details on how to upload a project in the Niko Home Control programming software, see Software Manual Niko Home Control II: Uploading.

Troubleshooting the DALI-2 addressable module

Problem

Proposed solution

Cannot search for DALI devices.

Check if the DALI module has been configured and addressed in the Niko Home Control programming software.

No DALI devices found.

Check the wiring of the DALI devices and try searching again.

A single channel has more than 64 DALI devices.

Remove the excess DALI devices. You can only connect 64 DALI devices per channel.

DALI device has a duplicate address. The DALI device has been used in another Niko Home Control installation.

Follow the instructions in the Niko Home Control programming software.

DALI device is present in the Niko Home Control programming software but not in the installation.

Follow the instructions in the Niko Home Control programming software.




JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.