Installing the push button

The push button features an easy click-on mechanism for wall-mounted bus wiring controls.
The following articles are required to install a single push button:

• a flush-mounting box (A)
• a simple wall-mounted printed circuit board (550-14110 or 550-141x6) or a multiple wall-mounted printed circuit board (550-14106 or 550-140xx) (B)
• a push button (C)
• faceplate (D)
• If you install a multiple wall-mounted circuit board, you also need a connection unit (550-14090).

• You can use a single flush-mounting box to install multiple push buttons (up to three horizontally or vertically) in one location.
• The wall-mounted printed circuit boards are available with claw and screw fixing. 

Mount the push button by pressing the connection unit onto a Niko Home Control wall-mounted printed circuit board until it clicks into place.
It will automatically connect to the Niko Home Control bus through two contact springs.
Mind the orientation of the push button: the spring contacts should be located at the bottom.
In closing, mount the faceplate (D) on the printed circuit board via the SnapFit mechanism.

	A. Single flush-mounting box (not a Niko product) B. Single wall-mounted printed circuit board C. Push-button D. Faceplace
Installation diagram for single wall-mounted printed circuit board