Skip to main content
Skip table of contents

Operation of the push button

Use of the action button(s)

Each generic action button can be programmed either to:

  • switch a light circuit

  • dim a dimmable light up or down, control a roll-down shutter or sun blind up or down (both in a single-button mode)

  • activate a routine, set a mood, or house status (these can be a combination of pre-programmed output settings)

Single-button mode behaviour for a dimming channel

Button

Behaviour

Short press

Toggles the dimmed light device ON or OFF. Depending on the memory mode of the dimmer channel, the ON state amounts to 100% of the light output or equals the previous dimming value.

Long press

Starts the dim-up or dim-down cycle of a dimmer channel, depending on the previous direction.

Release

Stops the dim-up or dim-down cycle at a certain intermediate dimming percentage.


Single-button mode behaviour for a motor channel

Button

Behaviour

Short press

Switches the motor to the following states respectively: run-up – stop – run-down - stop.

Long press

Starts the run-up or run-down cycle of a motor channel, depending on the previous running direction before the last stop.

Release

Stops the run-up or run-down cycle at a certain intermediate percentage.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.