Display controls
Description
The following display controls are available:
If the push buttons with display are integrated in a bridge, the bridge is mounted onto a standard flush-mounting box using screws (see installation instructions below). Otherwise, the device features an easy click-on mechanism for wall-mounted bus wiring controls; in that case, installation instructions are included in the hardware manual of the specific device.
Installation: push buttons with display that are integrated in a bridge
Strip the wires of the bus cable 9 - 10 mm.
A maximum of two wires with a diameter of 0.5 - 1 mm each can be connected per contact.
Connect the push button to the two-wire bus cable. Use the dual plug-in connector on the back of the control panel. This is marked with BB. Connect each wire separately to one of the contacts.
The push button with display is now connected. Use the other opening of the contact to establish a connection to the next control element if required.
Mount the bridge onto the single flush-mounting box using screws in order to secure the push button with display. Use a bridge with a set of claws if no screw holes are provided in the flush-mounting box.
Two types of bridges are available:bridge 60 x 71 mm with claw fixing (Belgium)
bridge 71 x 71 mm with screw fixing (the Netherlands)
Complete the installation using the flush surround plate of your choice from our series Niko Pure, Niko Intense or Niko Original.
