Skip to main content
Skip table of contents

Programming the push button with LED(s)

Button function

Use the Niko Home Control programming software to assign a basic action or a routine to each action button. 

Feedback LED behaviour

Configure the feedback LED behaviour for a basic action in the Niko Home Control programming software. It can be set to:

  • provide either direct or inverted feedback on a basic action/routine

  • serve as an orientation light (= 'Always ON')

  • 'Always ON'

  • 'Always OFF'

The default behaviour of the feedback LED is determined by the type of basic action/routine linked to an action button.
Bear in mind that some dedicated routines have a fixed LED behaviour.

Physical button addressing

Each action button has a unique address and needs to be assigned to a button created in the programming software.
This address is registered during the addressing phase by pressing one of the action buttons.
Via an upload, it is stored on the connected controller for further operation.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.