General solution: solar energy flows via measuring module
What do you need?
Niko requirements
Your Niko Home Control installation meets the following requirements:
It has a wireless smart hub or a connected controller II.
It is configured with the most recent programming software.
Depending on the installation type, you need the following connections and additional products:
In case you have a connected controller, install and connect a measuring module on bus or a wireless measuring module (the wireless bridge is strictly needed to connect a wireless measuring module).
In case you have a wireless smart hub, install and connect a wireless measuring module.
Third-party requirements
Your system meets the following requirements:
It has a single-phase or three-phase inverter.
It can be a hybrid inverter, connected to both the battery and solar panels. However, in that case the measuring module can only measure a combined energy flow of that battery and solar panels.
Wiring diagrams
Connecting a measuring module on bus
In case you have a single-phase inverter, you can measure the inverter and two other circuits:
In case you have a three-phase inverter, you will need all clamps of the measuring module to measure the energy flow of the inverter:
 |  |
Connecting a wireless measuring module
In case you have a single-phase inverter, you can measure the inverter and two other circuits:
In case you have a three-phase inverter, you will need all clamps of the measuring module to measure the energy flow of the inverter:
 |  |
Programming
Configure the measuring module via the Niko Home Control programming software. For more information, see Creating an energy reading.