Skip to main content
Skip table of contents

Manual use of the connected double switch, Zigbee®

Configuration

The connected switch, Zigbee® works autonomously with a toggle function and does not require configuration. If you press the button, it will switch its own contact and activate the corresponding lighting circuit. Press the button again to switch off the built-in contact. The state of the built-in contact is visualised by a feedback LED, which can be disabled manually by pressing the PROG button for 10 seconds.

A connected switch, Zigbee® that is used in stand-alone mode will not use the mesh networking capability and will not be upgraded automatically. For more details, refer to Zigbee® network principle.

Feedback LED

Disable the white feedback LED

  • The white feedback LED is active by default

  • Press the PROG button for 10 seconds

  • The blue LED turns ON after 2 seconds and subsequently turns OFF after 10 seconds

  • The white LED is disabled

Enable the white feedback LED (after it has been disabled)

  • Press the PROG button for 10 seconds

  • The blue LED turns ON after 2 seconds and subsequently turns OFF

  • The white LED lights up again when the connected switch, Zigbee® is used

Stand-alone use

See Connected double switch, Zigbee®, 2 x 10 A

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close