Skip to main content
Skip table of contents

Duco and Niko Home Control

For an installation with version 2.16 or earlier, the link between Niko Home Control and Duco can be activated and deactivated on mynikohomecontrol.niko.eu.

What can you do with Niko Home Control?

By using Niko Home Control with your DucoBox, you can do the following:

  • Control the ventilation speed

  • Choose the ventilation program mode (e.g. away, audio)

  • Check the CO2 concentration

  • Check the relative humidity level

  • Boost the ventilation

The Duco functions automatically appear in your Niko Home Control apps and your touchscreens after you activate the link between both systems. These functions can also be combined in routines/actions to control multiple items simultaneously at a simple press of a button (e.g. turn off all the lights and activate the ventilation boost to refresh the indoor air when pressing the leaving the house button).

  • The available functionality within Niko Home Control depends upon the specific installation features of the DucoBox.

  • You can always use the Duco Ventilation app for more advanced settings and configurations.


What do you need?


In short

Extra information

General

  • No additional electrical wiring is required.

  • Both systems are connected to the same home network via cable and/or Wi-Fi.

  • You have a computer with a web browser and an internet connection to set up the link between both systems.

A cabled connection is the preferred solution.

Your Niko Home Control installation meets the following requirements:

  • It has a wireless smart hub or a connected controller II.

  • It is configured with the most recent programming software (version 2.17 or higher).

  • It has an active internet connection.

  • It is registered.

  • If you want to use the DucoBox functions in combination with Niko Home Control actions, these actions need to be programmed with the Niko Home Control programming software after the link has been activated.

If you have not registered your Niko Home Control installation, go to Register your installation.

Your Duco system meets the following requirements:

  • It is a DucoBox having a communication print.

  • It has an active internet connection.

By default, all DucoBoxes have the same hostname.  If your installation is equipped with more than one DocuBox you have to make sure their hostnames differ from each other. 

The communication print:

  • comes as a standard with the DucoBox Eco.

  • can always be added to the DucoBox Silent Connect and the DucoBox Energy.

  • can be added to the DucoBox Focus, only when the printed circuit board shows version 2017.

You can change the hostname on the display e.g. in case of two Ducoboxes you can use Duco001 and Duco002. For more information, see your Duco manual.


How do you activate the link between your Niko Home Control and your DucoBox?

You have to set up the connection and functionality via the Niko Home Control programming software. Ask your professional installer for help.


How do you deactivate the link between your Niko Home Control and your DucoBox?

You deactivate the link with the Niko Home Control programming software. Ask your professional installer for help. 

After deactivating the link, the following happens:

  • The Duco functions disappear from your Niko Home Control apps, your touchscreens and Digital blacks.

  • When used in Niko Home Control actions, the Duco functions will not be executed anymore.

How do you update the Niko Home Control basic actions and routines that use your Ducobox?

You update the basic actions and routines with the Niko Home Control programming software



JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.