Skip to main content
Skip table of contents

Programming in a few simple steps

You can program the Niko Home Control programming software II version 2.x in the following steps:

  1. Create a project and enter project information
  2. Import a floor plan and/or draw rooms
  3. Add controls, devices, basic actions, routines, conditions and time schedules
  4. Only for the connected controller installation type: Create a cabinet, fill the cabinet with modules and assign devices to the modules
  5. Addressing
  6. Upload the project to the connected controller or smart wireless hub
  7. Test.


You can program in steps. To upload part of your programme, you must go through steps 4, 5 and 6.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.