Skip to main content
Skip table of contents

Connect to network

Procedure

Before you can use the Powerline tool, you must connect your PC to the same network as your 2-wire IP access control system. Choose one of the following methods:

  • Connect your PC to the same internet network, via Wi-Fi or a UTP cable to the router.

  • Connect your PC directly to the Access control module. Plug one end of a UTP cable into your PC and the other end into the module:

Connect UTP cable
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close