Description
Push buttons for motor control are available as single motor control (three action buttons) or double motor control (2 x three action buttons). They allow the resident to operate the motors of one or two groups of roll-down shutters, sun blinds or venetian blinds integrated in the Niko Home Control installation.
Overview
Operation
The specific action buttons on each push button are arranged in groups of three. Each group consists of the following buttons: "A", "B" and "C".
Action buttons with status LED will indicate in which rotation direction the end has or hasn´t been reached. The LEDS can be programmed so that they light up when the end has or hasn´t been reached. This can be determined in the programming software.
The table below provides an overview of all action button functions.
‘Before’ status | Action | ‘After’ status |
---|---|---|
No motion | Briefly press "A" (< 0.4 s) | Fully open / upward motion |
No motion | Briefly press "B" (< 0.4 s) | Preference setting (standard 50%) |
No motion | Briefly press "C" (< 0.4 s) | Fully closed / downward motion |
No motion | Hold down "A" (≥ 0.4 s) | Opens / upward motion until the button is released. |
No motion | Hold down "B" (> 3 s) | The current position is now saved as the new preference setting. |
No motion | Hold down "C" (≥ 0.4 s) | Closes / downward motion until the button is released. |
In motion | Briefly press "A" (< 0.4 s) | Stops |
In motion | Briefly press "B" (< 0.4 s) | Stops |
In motion | Briefly press "C" (< 0.4 s) | Stops |
In motion | Hold down "A" (≥ 0.4 s) | Stops |
In motion | Hold down "B" (≥ 0.4 s) | Stops |
In motion | Hold down "C" (≥ 0.4 s) | Stops |
Installation
The push button features an easy click-on mechanism for wall-mounted bus wiring controls. Mount the push button by pressing the connection unit onto a Niko Home Control wall-mounted printed circuit board until it clicks into place. A. Single flush-mounting box (not a Niko product) B. Single wall-mounted printed circuit board C. Push-button D. Faceplace
The following articles are required to install a single push button:
It will automatically connect to the Niko Home Control bus through two contact springs.
Mind the orientation of the push button: the spring contacts should be located at the bottom.
In closing, mount the faceplate (D) on the printed circuit board via the SnapFit mechanism.Installation diagram for single wall-mounted printed circuit board
Technical data
- working voltage: 26 Vdc (SELV, safety extra-low voltage)
- ambient temperature: 0 - 50°C