Wi-Fi reset
As of version 2.15 of the Niko Home Control programming software, a reset will remove your wireless network settings.
Switch on the mains.
Step | Action | Duration | LED behaviour | |
---|---|---|---|---|
1 | Press the control button on the smart hub. | After pressing for 2 seconds, the blue LED will be continuously on. You can release the button | ||
2 | Press the control button on the smart hub. | blue LED flashing | ||
After pressing for 10 seconds, the blue LED will be continuously on for 4 seconds. You can release the button | ||||
3 | The red LED is flashing. The Wi-Fi reset has been completed successfully Important: If a green LED is continuously on after the Wi-Fi reset, the smart hub is still connected to your home network via a UTP cable |
You can watch the tutorial here:
General reset
A ‘general’ reset is done by uploading an empty configuration file to the Niko Home Control programming software.
Troubleshooting
Problem | Solution |
---|---|
The smart hub is not connected to your home network and has no internet connection. The red LED is flashing. |
|
The smart hub is connected to your home network but has no internet connection. | Check your home network internet connection. You can use your smart hub in your home network without an internet connection. |
I want to connect the smart hub to a different network. The red LED is not flashing. | Reconfigure the smart hub’s Wi-Fi network connection:
|
The smart hub is connected to a Wi-Fi network whose SSID was set to “hidden” after the initial connection with the smart hub. The smart hub won’t reconnect to the hidden SSID. | Make the SSID visible again. The smart hub should automatically reconnect to the Wi-Fi network after a few minutes. If this is not the case, do a reboot or power cycle of the smart hub and check again if it reconnects (see LED-funktioner i smart hubben). |