Skip to main content
Skip table of contents

Push buttons with display


Four types of push buttons with display are available:


Push buttons with display are integrated in a bridge. The bridge is mounted onto a standard flush-mounting box using screws.

  1. Connect the push button to the two-wire bus cable. Use the dual plug-in connector on the back of the control panel. This is marked with BB. Connect each wire separately to one of the contacts.

    • Strip the wires of the bus cable 9 - 10 mm.
    • A maximum of two wires with a diameter of 0.5 - 1 mm each can be connected per contact.

    The push button with display is now connected. Use the other opening of the contact to establish a connection to the next control element if required.

  2. Mount the bridge onto the single flush-mounting box using screws in order to secure the push button with display. Use a bridge with a set of claws if no screw holes are provided in the flush-mounting box.
    Two types of bridges are available:
    • bridge 60 x 71 mm with claw fixing (Belgium)
    • bridge 71 x 71 mm with screw fixing (the Netherlands)
  3. Complete the installation using the flush surround plate of your choice from our series Niko Pure, Niko Intense or Niko Original.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.