Skip to main content
Skip table of contents

Manual use of the wireless battery-powered switch, fourfold, Zigbee®


Configuration

Without a central gateway, the fourfold wireless battery-powered Zigbee® switch acts as a stand-alone control (transmitter) and can be paired with up to 8 Zigbee® receivers (ON/OFF/dimming), such as dimmable LED bulbs.

RGB colour control and tunable white control are not supported by the fourfold wireless battery-powered Zigbee® switch in stand-alone use.

The fourfold wireless battery-powered Zigbee® switch supports both Touchlink pairing and Find&Bind pairing for stand-alone use in decentral networks.

Touchlink pairing

Reset all Zigbee® devices if they were previously connected to another network, before starting Touchlink pairing. See § Reset


Step

Action

Enable Touchlink mode with the receiver (for example, a Zigbee® bulb) and bring the fourfold wireless battery-powered switch Zigbee®within 10 cm of the receiver.

Press the PROGRAM button at the back of the fourfold wireless battery-powered switch Zigbee®for 2 seconds. The program LED will turn ON.


Press the button on the fourfold wireless battery-powered switch Zigbee® twice within 4 seconds to enable Touchlink pairing. The PROGRAM LED will blink twice repeatedly for a maximum of 90 seconds and will search for a Touchlink receiver.

The fourfold wireless battery-powered Zigbee® switch is successfully paired with its stand-alone Touchlink receiver when the PROGRAM LED turns ON for 4 seconds and then turns OFF again.

  • When in stand-alone mode, a wireless battery-powered Zigbee® switch will not use the meshing capability and will not be upgraded automatically. For more details, refer to Zigbee® network principle

  • Maximum 8 Zigbee® receivers (ON/OFF/dimming) can be paired to the same wireless battery-powered Zigbee® switch

  • A battery-powered Zigbee® switch in stand-alone mode will not support any of the following Niko Home Control features: smartphone control, battery low indication, OTA firmware upgrade, flexible configuration to any receiver and others. For more information, see Connected Use


Stand-alone use

See Wireless battery-powered switch, fourfold, Zigbee®

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.