Skip to main content
Skip table of contents

DALI-2 addressable module, 2 channels


The DALI-2 fully addressable 2-channel interface module allows up to 128 DALI endpoints to be connected to a Niko Home Control installation. Addressing and programming of the DALI devices is done from within the Niko Home Control programming software, and no prior DALI knowledge is required. Each of the DALI endpoints can be configured and controlled separately, without the need to use any other DALI software or interface. The module comes with a built-in power supply, so there is no need to use a dedicated DALI power supply for the DALI bus.




Technical data





Article number


Input voltage230 Vac (± 10%), 50 Hz
Wire capacity2 x 1.5 mm² / 2 x 2.5 mm² / 1 x 4 mm²
Mounting methodDIN rail
Maximum power consumption11 W
Power consumption (standby)1.9 W
Power supplybuilt-in DALI power supply
DALI protocolEN62386
Supported DALI devicesDALI control gear DT0 to DT7
DALI transmission rate1200 bit/s
DALI output voltage12 - 20.5 V
Maximum number of DALI outputs per channel64
Maximum output current per channel250 mA
Maximum guaranteed current per channel175 mA
Dimmingabsolute and relative
Protectionshort-circuit, surge voltage, overload
DALI short circuitretry mechanism
ConfigurationNiko Home Control programming software
ControlNiko Home Control II app / Niko Home app
System compatibilityNiko Home Control II
Weight137 g
Ambient temperature0 - 45 °C
Dimensions (HxWxD) (mechanism)90 x 70 x 67 mm (DIN U4)
Protection degreeIP20

Supported DALI control gear

The table below shows the supported DALI control gear in Niko Home Control II.

PartType of control gearDevice type number
201Fluorescent, lamp control gearDevice Type 0 (DT0)
202Self-contained emergency, control gearDevice Type 1 (DT1)
203Discharge HID, lamp control gearDevice Type 2 (DT2)
204Low-voltage halogen, lamp control gearDevice Type 3 (DT3)
205Incandescent lamp, dimmerDevice Type 4 (DT4)
206Conversion to DC voltage (1 - 10 V, 0 - 10 V converter)Device Type 5 (DT5)
207LED lamp, control gearDevice Type 6 (DT6)
208Switching, relay control gearDevice Type 7 (DT7)

Device type 8 (colour control gear) is not yet supported in Niko Home Control II.

Note: Colour control is enabled with DALI-2 addressable modules for Niko Home Control in a lighting network containing LED drivers that support an operating mode with dual DALI addresses.
The DALI-2 addressable module for Niko Home Control will detect LED drivers with a dual DALI addressing mode as two separate DALI devices.
One DALI address can then be configured to change the light intensity, and the other DALI address can be used to configure the colour or colour temperature.
Examples of LED drivers that support dual DALI addressing include the products from Lunatone with operating modes Balance & Dim or Colour & Dim.

Supported DALI control devices

DALI control devices are not supported in Niko Home Control II.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.