Skip to main content
Skip table of contents

Connected single switch, 10 A


The connected single switch has a switching contact to switch lighting. It contains a transmitter and receiver that can communicate wirelessly with the wireless smart hub for Niko Home Control.

You can use the connected single switch to replace a conventional switch. It is equipped with an extension terminal so that, in combination with a conventional push button, it can easily replace multiway or intermediate switching.

The connected single switch can switch its own contact.

Once connected to the wireless smart hub for Niko Home Control, it is possible to configure additional functionalities with the Niko Home Control programming software. For example, you can add the switch to a mood or all-off function.

It is possible to disconnect the control from its built-in contact. That way, you have complete flexibility to configure the switching contact and the controls separately via the programming software.





Switch off the mains.



Switch off the mains.


In an installation without a wireless smart hub, the switch will control the wired lamp. More advanced options become available if you use a wireless smart hub and the Niko Home Control programming software.

Download the Niko Home Control programming software:


You watch the tutorial here:

Technical data

Dimensions in mm





Article number551-721x1
Power supply230 Vac
Mounting methodWall mounting
Mounting height110 - 120 cm
Weight70 g
Ambient temperature0 - 40 °C
Dimensions (HxWxD) - 551-72101, 551-7212171.5 x 73 x 40 mm
Dimensions (HxWxD) - 551-7211173 x 73 x 40 mm
Protection degreeIP20
Modification of settingsNiko Home Control programming software (requires wireless smart hub 552-00001)
Maximum range (from switch to wireless smart hub)30 m
Operating frequentie869.05 MHz
Maximum power frequency6 dBm
Wire capacity2 x 2.5 mm2
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.