You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

Switch off the mains.

  1. Install all connected and/or wireless Niko devices.


    2 m ≤ * < see specifications of the specific Niko device

  2. Connect the wireless smart hub via WiFi or with an UTP cable.

    WiFiUTP cable

  3. If you connected the smart hub via WiFi, connect your mobile device to the following WiFi network:
    • network name: "Niko smart hub" followed by the last 4 characters of the smart hub's MAC address (XX:XX).
    • password: serial number of the smart hub (SN: XXXXXXXXXX). 
      Result: On mobile devices the smart hub's web portal opens automatically.

  4. To set the smart hub's network connection, proceed as follows:

    1. Open a web browser and go to the  address: Nikoxxxx.local (xxxx = the last 4 characters of the smart hub’s MAC address (XX:XX)).

      On a mobile device the smart hub's web portal is already open.

    2. Enter the password. The password is the smart hub’s serial number (SN:XXXXXXXXXX).
      Result: An overview of all available wireless networks is shown.

    3. Select your preferred network for the smart hub. (if applicable) Enter the password for this network.
      Result: The smart hub connects to your own wireless network. The smart hub stops broadcasting its own WiFi network.

    To make changes to the wifi configuration of the smart hub, restart the smart hub by cutting the power supply for a couple of minutes. The smart hub will then transmit its own wifi network again for 5 minutes.

  • No labels