Skip to main content
Skip table of contents

Saunier Duval and Niko Home Control

For an installation with version 2.16 or earlier, the link between Niko Home Control and Saunier Duval can be activated and deactivated on mynikohomecontrol.niko.eu.

What can you do with Niko Home Control?

By using Niko Home Control with your Saunier Duval system, you can do the following:


Connected systems supported by 

MiGo app

MiGo Link app

Check and control the room temperature (one zone)

Check and control the room temperature (more zones)


Check the outside temperature

Choose the heating program mode (e.g. home, away)


Choose the operation mode (e.g. summer, winter, frost guard)


Check and boost the temperature of the hot water system


Choose the heating program mode (off, manual, schedule, away, boost) (*)


(*) Boost is only available for domestic hot water.

The Saunier Duval functions automatically appear in your Niko Home app and on your touchscreen after you activate the link between both systems. To control the Saunier Duval functions on your Digital bIack, select the Saunier Duval controls for your Digital black in the Niko Home app. The functions can also be combined in routines/actions to control multiple items simultaneously at the simple press of a button.

  • The available functionality within Niko Home Control depends upon the specific installation features of the Saunier Duval system.

  • You can always use the MiGo app or MiGo Link app for more advanced settings and configurations.


What do you need?


In short

Extra information

General

  • No additional electrical wiring is required.

  • You have a computer with a web browser and an internet connection to set up the link between both systems.


Your Niko Home Control installation meets the following requirements:

  • It has a wireless smart hub or a connected controller.

  • It is configured with the most recent programming software (version 2.17 or higher).

  • It has an active internet connection.

  • It is registered.

  • You have your Niko Home Control installation e-mail address and password on hand.

  • If you want to use the Saunier Duval functions in combination with Niko Home Control actions, these actions need to be programmed with the Niko Home Control programming software after the link has been activated.

If you have not registered your Niko Home Control installation, go to Register your installation.

Your Saunier Duval system meets the following requirements:

  • It is a Saunier Duval boiler/heat pump having a Saunier Duval  communication unit.

  • It has one of the following thermostats:

    • thermostat supported by the MiGo app

    • thermostat supported by the MiGo Link app.

  • It has a MiGo thermostat.

  • It has an active internet connection.

  • You have the serial number of the communication unit on hand.

You can find the serial number of the communication unit:

  • on the backside or the inside of the unit below the barcode

  • in the MiGo app or MiGo Link app


How do you (de)activate the link between your Niko Home Control and your Saunier Duval system?

You can (de)activate the link between Niko Home Control and your Saunier Duval system via the Niko Home Control programming software.
Note that any basic actions and routines linked to your Saunier Duval system are also updated via the programming software.
You will find the requirements and detailed instructions in the software manual.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.