Skip to main content
Skip table of contents

Energy monitoring with eco-display

What is Energy monitoring with eco-display?

With the routine Energy monitoring with eco-display you can configure which energy channel is displayed on the eco-display.
You can also select the following measured energy channels:

  • electricity consumption

  • electricity yield

  • gas consumption

  • water consumption

Starting point

  • You have created the following:

    • eco-display

    • single-phase electricity reading

    • three-phase electricity reading

    • electrical pulse reading

    • water reading

    • gas reading

  • You are in the Create overview window.

Procedure

  1. In the right-hand button bar, click on the button Routine.
    Result:
    The Routine pane appears.

  2. Choose the room as follows:

    • Choose Room from the drop-down list.

    • Click on the room in the drawing area.

  3. Click on the arrow next to the category Energy management.

  4. Click on Energy monitoring with eco-display.


  5. Give the routine a name.

  6. Set the behaviour as follows:

    BehaviourWhat?How?
    AChoose the eco-display where you want to display the energy values measured.

    Click on the symbol of the eco-display you want to include in the routine.

    You can only add one eco-display per routine.

    BChoose the energy channels for which you want to display the values on the eco-display.

    Click on the symbols of the energy channels.

    You can add several channels per routine.



    At least one control or device is required for both behaviour A and behaviour B. If you do not add this control or device, the routine symbol will show a warning. Underneath the behaviour the following message will be displayed: you have to add at least one control or device to complete the action.


  7. In this routine you cannot set any parameters. You can, however, adjust other settings that affect this routine.

    Click on ...To ...
    Dashboard > Project info and settings > Global settings

    adjust the currency and rates of the readings. 

    the devices in the drawing area:

    • single-phase electricity reading
    • three-phase electricity reading
    • electrical pulse reading
    • water reading
    • gas reading
    • add a short name (this will be displayed on the eco-display);
    • choose between a global reading of consumption, a partial reading of consumption and, for electricity, a reading of the yield;
    • enter the number of pulses per unit: pulses/kWh for electricity and pulses/ for water and gas.


Video

See an example here. Turn on the sound to watch the video.

https://www.youtube.com/embed/r20oeBpcmz4


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.