Skip to main content
Skip table of contents

Output not unlocked

If you have 'locked' an output in an action, but have not provided for this to also be 'unlocked', you may see this message when uploading: 

Some outputs are locked by an action, but are never unlocked: output x

This message means: Some outputs have been locked in an action but have not been unlocked: output x.

In order to resolve this problem, click Creation

You will then move into the screen where you can add actions, outputs and inputs.

Add an unlock for the relevant output. This can be done via an existing or a new action.

If the lock has no further value for the installation, you can also delete it from the project. To do so, go to the action in which you have set the lock and modify the basic behaviour.

Go back to the Realisation step in the menu at the top of the screen.

You now go to the address modules tab.

Click on the upload tab. 

You can now upload the project again.

Click on upload at the bottom of the screen. 

A warning will appear, indicating that the existing programme will be overwritten.

Click on upload.

Once the upload is complete, the software will report that the installation has been programmed.

Click on close project.

A warning will appear, asking if you wish to save the project.

Click on save.

You will return to the Niko Home Control software start screen.

The project is saved and closed.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.