Output not locked

If you wish to unlock an output in an action, but this cannot be locked, you may see this message when uploading: 

Some outputs are unlocked by an action, but are never locked: output x

This message means: Some outputs have been unlocked in an action but have not been locked: output x.

In order to resolve this problem, click Creation. 

You will then move into the screen where you can add actions, outputs and inputs.

Add a lock for the relevant output. This can be done via an existing or a new action.

If the unlock has no further value for the installation, you can also delete it from the project. To do so, go to the action in which you have set the lock and modify the basic behaviour.

Go back to the Realisation step in the menu at the top of the screen.

You now go to the address modules tab.

Click on the upload tab. 

You can now upload the project again.

Click on upload at the bottom of the screen. 

A warning will appear, indicating that the existing programme will be overwritten.

Click on upload.

Once the upload is complete, the software will report that the installation has been programmed.

Click on close project.A warning will appear, asking if you wish to save the project.

Click on save.You will return to the Niko Home Control software start screen.

The project is saved and closed.