Output not assigned
If you have not yet assigned an output to a module, you may see this message during upload:
This message means that the output with name 'x' is used in the action with name 'y' but not assigned to a module.
In order to resolve this, go back to Cabinet set-up.
Go to the Assemble the cabinet screen.
Click on the cabinet name in the left hand side of the screen.
The Cabinet properties tab will appear.
On the left, you will see a virtual cabinet.
Click on the Assign outputs tab.
Click on one of the added modules.
The orange ticks indicate which outputs have been correctly linked.
Go to the output that is not assigned to a module.
Click on save.
You return to the Assign outputs start screen.
Click on the row of the module which you wish to link the output that is not yet assigned.
The virtual module appears in the right hand side of the screen.
Click on the non-assigned output to link it to the module.
Click on save.
Click on save.
You will go back to the Assemble the cabinet screen.
Go back to the realisation step.
Click on the upload tab.
Click on upload at the bottom of the screen.
A warning will appear, indicating that the existing programme will be overwritten.
Click on upload.
Once the upload is complete, the Niko Home Control software will report that the installation has been programmed.
Click on close project.
A warning will appear, asking if you wish to save the project.
Click on save.
You will return to the Niko Home Control software start screen.
The project is saved and closed.